How to propagate Parthenocissus tricuspidata by cutting
Do you know about this? Introduction to the propagation of Parthenocissus tricuspidata by cutting and the cultivation and propagation techniques of green plants and flowers. Next, the editor will introduce it.
Also known as creeping fig, Parthenocissus tricuspidata is a large, deciduous, woody vine of the grape family. There are two methods of cutting propagation: hardwood cutting and softwood cutting. Hardwood cutting can be done between March and April in spring, while softwood cutting can be done between March and April in spring or June and July in summer. Select healthy, pest-free, and robust branches as cuttings, and use soil with good drainage and aeration as the substrate. Insert the cutting into the substrate to a depth of 1/3 and water thoroughly.
1. Cutting Time
Parthenocissus tricuspidata can be propagated by either hardwood or softwood cuttings. Hardwood cuttings can be taken between March and April in spring, while softwood cuttings can be taken between March and April in spring or June and July in summer.
2. Cutting Selection
Whether using hardwood or softwood cuttings, select healthy, pest-free, and robust branches. Cut to a length of 10 to 15 cm, leaving 2 to 3 leaves at the top, and remove the rest. After cutting, apply carbendazim to the wound for disinfection and let it air-dry in a well-ventilated area until the wound contracts.
3. Substrate Preparation
The substrate for cutting should have good drainage and aeration. It can be prepared by mixing one part decomposed leaf soil, two parts river sand, and one part garden soil. Before cutting, place it in the sun for 1 to 2 days or mix it with carbendazim for disinfection.
4. Performing the Cutting
Soak the cuttings in a rooting hormone solution for 1 hour before cutting to promote root growth and increase the survival rate of cuttings. Insert the cutting into the substrate to a depth of 1/3, press the surrounding substrate, and water thoroughly.
5. Care and Management
After cutting, place the cuttings in a semi-shaded, well-ventilated, and warm environment. Water when the surface of the substrate is slightly dry and white, stopping when water渗透ates from the bottom of the substrate. Keep the substrate moist. In about 30 days, the cuttings can root, and they can be transplanted into pots when the roots are well-developed.
The above sharing on how to propagate Parthenocissus tricuspidata by cutting and the complete content of cultivation and propagation techniques are for your comprehensive understanding and reference!