How to train the new branches of the climbing rose arch that are all at the top?
Today, the editor will explain the training of the new branches of the climbing rose arch that are all at the top in terms of green plant flowers, and a comprehensive introduction will follow.
Training Method and Precautions for Climbing Rose Arch
Training a climbing rose arch, especially in winter, can be quite difficult, especially for some thick-branched varieties such as Grand Parade and Red Dragon Sandstone.
Because the branches are too thick, it is difficult to shape them, so I personally suggest that if you are making an arch, it is best to choose a variety of climbing roses with relatively soft branches, such as Lavender Wreath, Luo Yi, Blue Rain, and Golden Celebration. The branches of these varieties are relatively thin and soft, making it easier to shape the arch.
For some large vines, if they are not pruned after flowering in the spring following their first year of being trained to the top of the arch, they may end up like the picture below.
If your rose arch is in this state, do you also feel at a loss for training? In fact, one of the important reasons for this problem is that no pruning was done after the spring flowers. The method of pruning climbing roses after flowering is detailed in the book "How to Grow a Burst of Roses from Scratch" if you are interested.
If the climbing rose arch has grown to this state, it still needs to be trained and shaped. Before training, some pruning is required. To make it clear, the following simple illustration is used to represent it.
How to train the new branches of the climbing rose arch that are all at the top?
First, cut off the shorter new branches and the old branches without thick new branches, and retain some thick long new branches. The number of branches in the diagram is small, but as long as the principle of pruning is mastered, it can be pruned in the same way.
After pruning the thin and weak branches, the short branches, and the old branches with poor vitality, you can start training. During the training process, unnecessary branches can be pruned again.
Then, horizontally fasten the branches retained at the top to the top of the arch, and prune the excess branches. As for the sides of the arch, only some of the shorter branches can be used to fill them.
For the side training of the arch, the branches are mostly arranged in an S shape. It is important to note that when bending the branches, the movement must be slow, and the angle should be rounded to prevent the branches from breaking.
The above introduces the training method and precautions for the climbing rose arch and detailed explanation of how to train the new branches of the climbing rose arch that are all at the top, hoping this article can bring you help in green plant management!