How to propagate roses
This article provides netizens with the experience of planting flowers related to rose propagation and understanding the key techniques of rose cutting. Below is a detailed introduction for you.
Friends who have been gardening for a long time often try to propagate flowers on their own, but success is not guaranteed with just propagation. Propagation requires a lot of skill, but many friends are not aware of these techniques, often resulting in failed attempts. Today, Flower expert will teach you how to propagate roses to increase their survival rate!
Rose propagation can be done throughout the year, but it is best done in spring and not in summer. The survival rate is highest in spring, while it is relatively low in summer. Many friends find that their propagated roses have sprouted new buds but die after a few days. What is the reason for this?
1. Choose strong branches
Many friends choose branches cut during pruning to maintain the beauty of the original potted plant without selecting them properly. These branches are often tender or dried, resulting in a lower survival rate. Choosing the right branches for propagation is very important. We must choose robust branches to ensure the survival rate of the cuttings!
2. Soak the branches
You can buy root-promoting powder online, mix it with water, and soak the branches for two hours. However, if you don't have root-promoting powder, you can mix vinegar and water at a ratio of 1:100 and soak the branches. Soaking the branches is a necessary step in the propagation process!
How to propagate roses
3. Choose soil
When choosing soil, select loose and nutritious soil, as simple, nutrient-rich soil is not suitable for rose propagation. To prevent soil compaction, remember to add some decayed leaf soil and river sand to the soil, along with a small amount of perlite. This is mainly to increase soil permeability and maintain good permeability for the plant!
4. Propagate
First, put the selected soil in the pot, then insert the previously chosen branches into the soil. On the surface of the soil, you can add a layer of perlite about 1cm thick. Then start watering, making sure to water the soil thoroughly the first time. After that, move the potted plant to a place with scattered light and let it sit for 5 days. After five days, you will see new buds on the propagated branches.
5. Post-propagation care
The appearance of new buds on our branches does not mean that the propagation process is over. We still need to provide careful care in the later stages. Make sure not to place the propagated branches in direct sunlight, as this is harmful to roses, and avoid moving the potted plant randomly.